Need to replace the seal that runs along the top of the lower half of my clam shell trailer. Current material is an inch wide and was originally a soft, low-profile material that nestled into the grove in the upper half when the trailer is closed. Any ideas appreciated before I delve into the internet for options.

Is you trailer a product of a recognized manufacturer?

On Wednesday, December 30, 2015 at 5:12:58 PM UTC-6, wrote:
> Is you trailer a product of a recognized manufacturer?

No...generic with no noticeable manufacturer. Thanks...Mark

Mark-

I have a source for adhesive backed neoprene seal strip. It comes in 1 inch width with thicknesses from 1/8 inch to 3/4 inch (1/8 inch increments. You might be able to find similar stuff from McMaster-Carr, but if you run into a problem, let me know and I can put you in touch with my supplier.

Email: Mark (at) mmfabrication (dot) com

On Wednesday, December 30, 2015 at 6:55:32 PM UTC-6, Mark628CA wrote:
> Mark-
>
> I have a source for adhesive backed neoprene seal strip. It comes in 1 inch width with thicknesses from 1/8 inch to 3/4 inch (1/8 inch increments. You might be able to find similar stuff from McMaster-Carr, but if you run into a problem, let me know and I can put you in touch with my supplier.
>
> Email: Mark (at) mmfabrication (dot) com

Thanks Mark. I appreciate it and have enjoyed the wing wheel you sold me for my ship while out for the OLC camp this year. It is awesome. I was fortunate you had one in stock! Mark